Videojet DataFlex 6530 Service Manual - Rev AA B-9
•HLD
Sends a PackML Hold command, which represents the PackML state transition from
STANDBY/PRODUCING to HOLDING. In CLARiTY terms it is equivalent to pressing the
button while the system is in the Running state. The success response is sent when the system
state reaches the target state. The failure response is sent if the state transition is rejected. If the
system is already in the target state when the command is received, a success response is
immediately sent without performing any action. If the system is in a state other than the source
or target states for this transition, the command is immediately rejected.
•ABT
Sends a PackML Abort command, which represents the PackML state transition from
STARTING/HELD/READY/STANDBY/PRODUCING to ABORTING. This command causes
an Abort fault to occur, thus setting the error state to Fault Present. The success response is sent
when the system state reaches the target state. The failure response is sent if the state transition is
rejected. If the system is already in the target state when the command is received, a success
response is immediately sent without performing any action. If the system is in a state other than
the source or target states for this transition, the command is immediately rejected.
•GST
Gets the PackML State as a decimal integer, with the following possible values:
• 0 STOPPED
•1 STARTING
•2 READY
•3 STANDBY
•4 PRODUCING
• 5 STOPPING
•6 ABORTING
•7 ABORTED
•8 HOLDING
•9 HELD
The command response string is:
<packmlstate><CR>
•GSX
Gets the PackML State as a string, with the following possible values:
STOPPED
STARTING
READY
STANDBY
PRODUCING
STOPPING
ABORTING
ABORTED
HOLDING
To Next Page
Loading...
