Videojet DataFlex 6530 Service Manual - Rev AA 5-5
CLARiTY Operating System
iAssure Enables or disables iAssure function.
iAssure scans the image printed on the
label and compares it to the job and
records the success/failure count of the
printed label.
Print Delay (ms) Sets the delay between the print signal
and the commencing of the print.
Measured in milliseconds, it allows
time for the packaging film to come to
a complete rest before the printhead
comes in contact. It should be set to the
smallest possible value that gives a
good quality print.
Print Speed Sets the target printing speed of the
head in mm/sec. It should be set to the
lowest speed that allows completion of
the print in the available dwell time of
the packaging film.
Print Darkness Sets the print darkness. The print
darkness is set between 50% and 100%.
Print Force Sets the force to be applied while
printing.
Note: It is recommended to retain at
default value with adjustment required
only if light print/poor ink transfer found.
Option Description
Table 5-3: Printhead Parameters in Intermittent Mode Description (Continued)
To Next Page
Loading...
