8-2 Videojet DataFlex 6530 Service Manual - Rev AA
Troubleshooting
E1002 Operation
Aborted
The operation of the printer was intentionally aborted by a
host control system. When ready to do so, the host control
system will clear this abort condition, and then this fault
message will automatically clear and the printer will resume
operation.
E1003 Realtime Clock
Fault
There is a problem with the Real time Clock which is required
for the system to operate correctly.
E1004 Backup
battery is flat
The battery which powers the printer's clock is flat. This
means that the date and time, the currently selected Job and
some performance data will be lost when the printer is
switched off.
E1005 Print Limit
Exceeded
The current Job was selected with a print limit (i.e. a limit on
the number of times the Job can be printed). This limit has
been reached but the printer has received a further print
signal that would have exceeded the limit.
This error will become clearable after selecting a new job.
Alternatively, a Job selection command or variable data
update from an external source will also make this error
clearable.
E1006 Image Update
Failure
CLARiTY was unable to update the image that will be printed
next. This usually occurs because products are too close
together. Press the Clear button to enable printing to be
restarted.
E1007 Image Update
Failure
CLARiTY was unable to update the image that will be printed
next. This usually occurs because products are too close
together. Press the Clear button to enable printing to be
restarted.
E1008 Power Failure
Detected
A serious drop in the mains power has been detected. In
order to protect the printer from damage, the high voltage
circuits have been switched off. You must now repower the
printer in order to resume printing. If the problem persists,
contact your maintenance engineer.
E1009 Corrupt MAC
Address
The MAC address of this printer is corrupt and the printer
cannot function without a valid MAC address. Contact your
maintenance engineer.
E1010 Invalid Line The line selection inputs have requested a line that is not
configured. Use CLARiTY Configuration Manager to check
that the correct number of lines have been setup for this
system. Also check that the line selection inputs are connected
properly. Press the Clear button, to clear this warning
message.
Error
Reference
Name Remedial Action
Table 8-1: Faults and Warnings (Continued)
To Next Page
Loading...
