VIDEOJET DataFlex 6530 - Page 83

Videojet DataFlex 6530 Service Manual - Rev AA 8-3
Troubleshooting
E1011 Production 
Disabled
A request to print a product has been received for a line that
production has been disabled on. Please press the Job button
on the home screen and check that the line configuration is
correct. Press the Clear button, to clear this fault message.
E1012 No Line
Selected
A print signal has been received for a product without any
line selection. Please check that the line selection system is 
functioning correctly. Press the Clear button, to clear this fault
message.
E1013 BETA Expired The beta period for the release has expired.
Contact your maintenance engineer to correct this problem.
E1014 Time and Date
may be
incorrect
The printers time and date may not be correct. The most 
common cause for this is that the battery used to backup the
printers clock is flat. If this problem returns the next time the
printer is power on then the battery should be replaced. If the
battery is flat the date and time, the currently selected job and
some performance data will be lost when the printer is
switched off.
Press the Clear button, to clear this warning message.
E1100 Invalid Job
File-
bad field 
reference
The Job file is invalid and needs to be corrected using 
CLARiSOFT. There is a circular reference between fields in
the Job file. Use CLARiSOFT to check and correct the 
relationships between fields in this Job file. Then, download
the corrected file.
Press the Clear button, to clear this fault message.
E1101 Invalid Job
File-missing
data source
field
The Job file is invalid and needs to be corrected using 
CLARiSOFT. A field in the Job file refers to another field for
its source of data, but that field is missing from the job file.
Use CLARiSOFT to ensure that all data source fields used in
the Job file are present and correct in the Job file. Then, 
download the corrected file.
Press the Clear button, to clear this fault message.
E1102 Invalid Job File
- duplicate
named fields
The Job file is invalid and needs to be corrected using 
CLARiSOFT. Duplicate field names were found in the Job file.
Use CLARiSOFT to remove or rename fields so that there are
no duplicates. Then, download the corrected file.
Press the Clear button, to clear this fault message.
E1103 Invalid Job File
- invalid
graphic
The Job file is invalid and needs to be corrected using 
CLARiSOFT. The Job file refers to a missing or invalid graphic
bitmap file. Use CLARiSOFT to check and ensure that all 
bitmap files, used by this Job file, display properly in 
CLARiSOFT. Then, download the corrected file.
Press the Clear button, to clear this fault message.
Error 
Reference
Name Remedial Action
Table 8-1: Faults and Warnings (Continued)