WinGD RT-flex50DF - Page 298

Maintenance3326−2/A2
Winterthur Gas & Diesel Ltd.
4/ 10
13) Attach the lifting rings (94332, Fig. 5) to
the cylinder block (6) with the
screws (5).
14) Torque the screws (5) to 200 Nm.
15) Attach the eye bolts (EB) to the guide
shoes (1, 4).
16) Connect the manual ratchets (H4, H5)
to the lifting rings (94332) and the eye
bolts (EB).
17) Operate the manual ratchets (H4, H5)
to hold the weight of the guide
shoes (1, 4) from the crosshead pin.
18) Remove the bolts (2, Fig. 6), tab
washers (5) and holding plates (3)
from the guide shoe (1).
Fig. 6
1
2
3
5
WCH03529
Crosshead Pin − Removal and Installation
2016
I
I
013.241/05
013.242/05
I - I
6
94332
5
3
94324
2
Fig. 5
H4
H5
EB EB
1
4