wsm B2420 - Check Points of Initial 50 Hours

GENERAL
B2420, WSM
G-15
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
CAUTION
To avoid personal injury:
• Be sure to stop the engine and remove the key before
changing the oil.
• Allow engine to cool down sufficiently, oil can be not and
can burn.
1. To drain the used oil, remove the drain plugs (1) at the bottom
of the engine and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Fill with the new oil up to the upper notch on the dipstick.
4. Properly dispose of used oil.
IMPORTANT
• Never mix two different types of oil.
• Use the proper SAE Engine Oil according to ambient
temperatures.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8.)
9Y1210436GEG0030US0
Replacing Engine Oil Filter Cartridge
CAUTION
To avoid personal injury:
• Be sure to stop the engine before changing engine oil filter
cartridge (1).
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the engine oil filter cartridge (1).
2. Put a film of clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly unit it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, replenish the engine oil up to the prescribed
level.
5. Properly dispose of used oil.
IMPORTANT
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
9Y1210436GEG0031US0
Engine oil Capacity
3.1 L
3.3 U.S.qts
2.7 Imp.qts
(1) Drain Plug
(2) Oil Inlet
(3) Dipstick
A: Oil level is acceptable within this
range
(1) Engine Oil Filter Cartridge
KiSC issued 06, 2012 A