ELECTRICAL SYSTEM
B2420, WSM
9-S23
(13) Flasher Unit
Flasher Unit Connector Voltage (Serial Number below 35597)
1. Disconnect the connector (2) from the flasher unit (1) after
disconnect the negative cord from the battery.
2. Connect the negative cord to the battery, and measure the
voltage with a voltmeter across the connector 1 terminal and 3
terminal.
3. If the voltage differs from the battery voltage, the main switch,
fuse or wiring harness is faulty.
Q Flasher Unit Actuation Test
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 60 to 120 flashers for a minute.
2. Set the main switch to the ON position and move the turn signal
switch to the left. Make sure the left-hand light gives flashes.
Then move the turn signal switch to the right and make sure the
right-hand light gives flashes. Make sure the same actions as
above result.
3. If both the hazard switch and the turn signal switch and the turn
signal switch function but the above actions do not take place,
replace the flasher unit with new one.
9Y1210436ELS0056US0
Voltage 1 terminal – 3 terminal Approx. battery voltage
(1) Flasher Unit (2) Connector (Wire Harness)
To Next Page
Loading...
