GENERAL
B2420, WSM
G-32
Replacing Fuse (Serial Number Above 33598)
1. The tractor electrical system is protected from potential damage
by fuses.
A blown fuse indicates that there is an overload or short
somewhere in the electrical system.
2. If any of the fuses should blow, replace with a new one of the
same capacity.
• Before replacing a blown fuse, determine why the fuse blew
and make any necessary repairs. Failure to follow this
procedure may result in serious damage to the tractor
electrical system. Refer to the "TROUBLESHOOTING"
section of this manual.
Q Protected Circuit
9Y1210436GEG0069US0
Replacing Light Bulb
1. Head lights:
Take the bulb out of the light body and replace with a new one.
2. Other lights:
Detach the lens and replace the bulb.
(When reassembling)
• When assembling the head light bulbs, apply liquid gasket
(Three Bond 1521 or equivalent) to joint face of the head light
and rubber.
9Y1210436GEG0055US0
Fuse No. Capacity (A) Protected circuit
(1) 15 Hazard
(2) 30 Key stop
(3) 25
Head Light,
Horn, Key stop
(4) 10 Brake
(5) 20 Auxiliary (Reserve)
(6) 10 Instrument Cluster
(7) Slow blow fuse
Check circuit against wrong battery
connection
Light Capacity
Head lights 45 / 40 W
Tail light 5 W
Turn signal / Hazard light 21 W
Instrument panel light 1.7 W
Hazard light switch indicator 0.6 W
Brake stop lights 21 W
Front position light 5 W
Number plate light 5 W
(1) Head Light
(2) Front Turn Signal / Hazard Light
(3) Front Position Light
(4) Tail Light
(5) Rear Turn Signal / Hazard Light
(6) Brake Stop Light
(7) Number Plate Light
(8) Easy Checker™
(9) Hazard Light Switch Indictor
To Next Page
Loading...
