X-Rite 962 - Page 44

SETTING INSTRUMENT CONFIGURATION
4-17
Hand Shake Selection
1. Use the Tab keys $@ to highlight Hand Shake. Press the
Enter # key to access the
Hand Shake editor.
2. Use the Tab keys $@ to highlight the desired handshake
method:
Off, CTS, BUSY, or XON. Press the Enter # key to
save your setting and return to the Serial Port Options menu.
Auto XMT Selection
1. Use the Tab keys $@ to highlight Auto XMT.
2. Press the Enter # key to toggle between
Off and On.
Separator Selection
1. Use the Tab keys $@ to highlight Separator. Press the
Enter # key to access the
Separator editor.
2. Use the Tab keys $@ to highlight the desired separator
command:
Space, Comma, Tab, CR, CRLF, or LF. Press
the Enter # key to save your setting and return to the
Serial Port Options menu.
Delimiter Selection
1. Use the Tab keys $@ to highlight Delimiter. Press the
Enter # key to access the
Delimiter editor.
2. Use the Tab keys $@ to highlight the desired delimiter
command:
CR, CRLF, or LF. Press the Enter # key to save
your setting and return to the Serial Port Options menu.
Data Types Selection
1. Use the Tab keys $@ to highlight Set Data Types. Press
the Enter # key to access the
Pick Data Types editor.
2. Use the Tab keys $@ to highlight the desired data type.
3. Press the Enter key # to toggle the data type active or
inactive. The > indicates the data type is enabled.
4. After edits are complete, press the Escape key ! to save
and exit.
Header Selection
1. Use the Tab keys $@ to highlight Header.
2. Press the Enter # key to toggle between
Off and On.
Std Printout Selection
1. Use the Tab keys $@ to highlight Std Printout.
2. Press the Enter # key to toggle between
Off and On.