SETTING INSTRUMENT CONFIGURATION
4-19
NOTE: Highlighting CLEAR and pressing the Enter key # is a quick
method to zero the value.
4. Use the Tab keys $@ to highlight the desired number and
press the Enter # key to exit the editor. If desired, change
the cal interval status from
On to Off.
5. When editing is complete, use the Tab keys $@ to highlight
Save & Exit and press the Enter # key.
Power Down
To access the Power Down Setup:
1. Use the Tab keys $@ to highlight Power Down.
Hardware Settings
Serial Port :9600
Read Oper. :Switch
Cal Timeout :24 hrs
Power Down :120 sec
Beeper :Soft
↓
2. Press the Enter # key to open the Power Down Time
menu.
Power Down Time
CLEAR
↓
120
↑
Save & Exit
3. Use the Tab keys $@ to choose the desired power down
digit (arrows above and below designate selection). Press
the Enter key # to access the alphanumeric editor.
NOTE: Highlighting CLEAR and pressing the Enter key # is a quick
method to zero the value.
4. Use the Tab keys $@ to highlight the desired number and
press the Enter # key to exit editor.
5. When editing is complete, use the Tab keys $@ to highlight
Save & Exit and press the Enter # key.
To Next Page
Loading...
