X-Rite 962 - Read Operation; Cal Timeout

CHAPTER FOUR
4-18
Emulation Selection
1. Use the Tab keys $@ to highlight Emulation. Press the
Enter # key to access the
Emulation Mode editor.
2. Use the Tab keys $@ to highlight the desired emulation
mode:
Off or 968. Press the Enter # key to save your
setting and return to the Serial Port Options menu.
Read Operation
To access the Read Operation Options:
1. Use the Tab keys $@ to highlight Read Oper..
Hardware Settings
Serial Port :9600
Read Oper. :Switch
Cal Timeout :24 hrs
Power Down :120 sec
Beeper :Soft
↓
2. Press the Enter # key to access the Read Operation
options.
3. Use the Tab keys $@ to highlight the desired read operation
mode:
RCI Only, Switch Only, Key Only, or
Switch and Key. Press the Enter # key to save your
setting and return to the Hardware Settings Options menu.
Cal Timeout
To access the Cal Interval Setup:
1. Use the Tab keys $@ to highlight Cal Timeout.
Hardware Settings
Serial Port :9600
Read Oper. :Switch
Cal Timeout :24 hrs
Power Down :120 sec
Beeper :Soft
↓
2. Press the Enter # key to open the Set Cal Interval
menu.
Set Cal Interval
CLEAR
↓
24
↑
On
Save & Exit
3. Use the Tab keys $@ to choose the desired cal interval digit
(arrows above and below designate selection). Press the
Enter key # to access the alphanumeric editor.