6. Enter a profile set name. Select Save.
The Create Color Profile Set screen displays.
NOTE
By default, the available quality level options supported on the Remote Printer
are shown. A calibration target prints for each selected quality level.
7. Deselect the Quality Levels you wish to exclude in the calibrated profile set.
8. Select Print.
The Printing Color Calibration Targets screen displays.
NOTE
During the calibration target print time, other copy and print jobs may still be
processed. To do this, select the Services button on the Control Panel and
proceed.
9. Select Close and collect your calibration targets from the remote printer.
NOTE
If any of the targets failed to print or were damaged in the print process, you
can select the Print button located on the Printing Color Calibration Targets
screen again. If you need to resume, start at the Current Color Calibration Session
screen.
10. You may choose to trim off the excess paper from the printed calibration targets to
reduce the size to be more manageable. Insert each calibration target into the scanner.
When you scan the printed calibration targets from the remote printer into the
scanner, it doesn’t matter in which order you insert them. Only the direction matters.
The arrow on the target gets fed first into the scanner.
The Processing Color Calibration Targets screen displays, followed by an hourglass,
while it processes each calibration target.
Once you scan all of the calibration targets, the Save button becomes active.
11. Select the Save button on the Create Color Profile Set screen to see the newly created
profile set in the list on the Select Color Profile Set screen. You have created your first
Xerox
®
6279
®
Wide Format Solution
3-36
Copy/Scan User Guide
Scanning Documents
To Next Page
Loading...
Need help?
General
