Configure Timers
The Configure Timers selection of the Control Panel screen allows you to set up the
values for the time-out features. The timeout features are defined on the following
pages.
Low Power Timeout
Sleep Timeout
Features Timeout
File Deletion Timeout
Print Interrupt Timeout
Low Power Timeout
This setting is the amount of time that must elapse since the last user operation, such
as a button press, until the machine enters the Low Power mode. The setting range is 5
to 240 minutes. The default setting for Low Power mode is 15 minutes.
1. Press the Services button on the Control Panel.
2. Select Machine Info from the Services menu screen.
The Machine Info screen displays. .
3. Select the Administration tab.
4. Select Control Panel.
5. Select Configure timers...
The Set Timeout Durations Screen displays.
6. Select Low Power Timeout.
The Set Timeout Duration Low Power Timeout screen displays.
7. Using either the scroll buttons or the numeric keypad, select the desired setting, and
then select Save.
8. Select Save to return to the Control Panel screen.
Sleep Timeout
The procedure for setting up the Sleep mode is as follows. The setting range is 5 to 240
minutes. The factory default setting for Sleep mode is 55 minutes.
1. Press the Services button on the Control Panel.
The Services menu screen displays.
2. Select Machine Info.
The Machine Info screen displays.
3. Select the Administration tab.
4. Select Control Panel.
5. Select Configure timers....
Xerox
®
6279
®
Wide Format Solution
5-16
Copy/Scan User Guide
System Administration
To Next Page
Loading...
Need help?
General
