Scan Offset
When the Scan Offset feature is enabled, and a scan offset position is defined, the
machine will ignore image information from the lead edge to the scan offset position.
This enables you to eliminate unnecessary detail from the lead edge of an original.
The scan offset position can be set up from 0 to 36.0 inches, in 0.1 inch increments.
The factory default is Disabled.
• Disabled: Scan offset will not be applied to the original.
• Enabled: A scan offset equivalent to the dimension you specify will be applied to the
original when it is scanned.
1. Press the Services button on the Control Panel.
The Services menu will display with Scan to Mailbox as an option.
2. Select Scan to Mailbox.
3. Select the Advanced Settings tab.
4. Select Scan Offset.
5. Select Enabled to define the amount of scan offset.
6. Set up the scan offset, using either the numbers keypad or the scroll buttons.
7. Select Save when finished.
TIP
When a Reduce/Enlarge ratio of other than 100% has been set up for the copy
job, the scan start position will be enlarged or reduced proportionately.
Color Space
1. Press the Services button on the Control Panel.
The Services menu will display with Scan to Mailbox as an option.
2. Select Scan to Mailbox.
Xerox
®
6279
®
Wide Format Solution
3-22
Copy/Scan User Guide
Scanning Documents
To Next Page
Loading...
Need help?
General
