Entering the Power Saver Mode
The Power Saver Mode may be entered either automatically or manually.
Automatic Method
The machine enters the Low Power Mode after a preset period elapses. The machine
enters the Sleep Mode from the Low Power Mode if the machine remains idle for an
additional, preset period.
Manual Method
Press the Power Saver button on the Control Panel. The button illuminates, the machine
enters the Low Power Mode and the Touch Screen backlight extinguishes.
Exiting the Power Saver Mode
The Power Saver mode may be exited either manually or automatically.
Manual Method
With the machine in the Power Saver mode, press the illuminated Power Saver button.
The button’s indicator light extinguishes, the Touch Screen displays the message Warming
Up, and the machine begins its warm up cycle.
Automatic Method
The machine exits the Power Saver mode when it detects a print job in the active queue.
NOTE
Refer to the System Administration chapter to learn how to customize the Power
Saver mode settings. This is a System Administrator only setting.
System Power On Procedure
The procedure below describes the process for powering up the system from a cold start,
that is, it assumes that both the Printer and Controller are powered down completely.
1. Move the printer Circuit Breaker switch to the On position (up).
1-15
Xerox
®
6279
®
Wide Format Solution
Copy/Scan User Guide
Product Overview
To Next Page
Loading...
Need help?
General
