Power Outage Job Status
Should the system loose power unexpectedly and reboot, jobs are restored to their
previous state. This is similar to using the Shutdown and Restart button.
• All Copy/Scan jobs in progress will restart from the beginning automatically, when
power is resumed unless job reprint was disabled.
• Completed, cancelled, checkplot and sample copy jobs are discarded since they are
not considered reprintable.
• Jobs that were processing during the power outage are placed in the Job Information
> Hold queue.
• Jobs finished processing and ready to start printing during the power outage are
placed in the Job Information > Active queue.
If Job Reprint is enabled:
Copy/Scan jobs that finished processing are automatically resubmitted for printing.
Copy jobs run before print jobs.
Copy/Scan jobs finished processing are displayed in the Job Information > Reprint
queue.
Copy/Scan jobs that did not finish processing are cancelled.
Shutdown from the User Interface
NOTE
Many of the features within the Administration tab require a password for access.
See your System Administrator for the password prior to getting started unless
the Administrator mode is already active.
NOTE
System Shutdown and Restart is used to reboot the system. This option will
not completely shut down the controller
1. Select Machine Info from either the Services menu, or by pressing the Machine Info
button located on the Control Panel.
2. Select the Administration tab.
3. Select General Administration.
4. If the Enter SA Password screen displays, enter the System Administrator password,
then press Enter.
5. Select Shutdown/Restart. . .from the General Administration screen.
Xerox
®
6279
®
Wide Format Solution
5-10
Copy/Scan User Guide
System Administration
To Next Page
Loading...
Need help?
General
