The Network Setup settings allow the System Administrator to setup the following
TCP/IP settings:
• IP Address
• Gateway
• Submask
• DHCP
If you do not know the above information, perform the following steps to generate a
Configuration Report:
1. Select Machine Info on the Services menu.
2. Select the Print Reports tab.
3. Select Printer Configuration.
Instead of entering the IP Address, Subnet Mask, and Gateway Address, you may
enable Dynamic Host Configuration Protocol (DHCP) on the Network Setup screen.
For more information on DHCP, see the Setting Up DHCP section of this chapter for
details.
If you are not already logged in as System Administrator, you are prompted for the
Administrator password when you select Network Setup. Contact your System
Administrator for the password if required.
NOTE
Whether you enter the network settings using the Web Printer Management
Tool or the User Interface, entering them in one place affects the other.
4. Select Machine Info from the Services menu.
5. Select the Administration tab.
6. Select Network Setup.
Xerox
®
6279
®
Wide Format Solution
5-20
Copy/Scan User Guide
System Administration
To Next Page
Loading...
Need help?
General
