Xerox WorkCentre 5024

Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
9-1
9
To o ls
Each machine feature is set to factory default (initial) settings, but you can customize these settings to
match your operating environment. You can change these settings in the Tools screen in System
Administration mode.
Note Some settings cannot be displayed on certain models. An optional component is required. For
more information, contact our Customer Support Center.
This chapter describes the functions you can change settings for and provides the settings procedures.
System Settings Procedure
This section gives an overview of how to change the machine's default settings and check machine
information.
Notes
• If there are any current or pending jobs you cannot enter System Administration mode. If there
are no current or pending jobs and you still cannot enter System Administration mode, there may
be a background process running. Wait 5 minutes and try again.
• While in System Administration mode you cannot receive a print job or start a print or scan job.
Entering System Administration Mode
1. Press and hold the Log In/Out button for at least 4 seconds.
Log In/Out button