Product Overview
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
3-10
You can set the amount of time the machine waits before entering Low Power mode from 1 to 60
minutes, and the amount of time the machine waits before entering Sleep mode from 1 to 239
minutes.
Note The life of the fusing unit is largely influenced by power distribution time on the machine. Setting
the amount of time the machine waits before activating the energy saver feature to a long value will
keep the machine's power on longer, and the fusing unit may have to be replaced more often. It may
cause an early replacement of the fusing unit of the machine. For more information, contact our
Customer Support Center.
For more information on how to set the time interval for Low Power mode and/or Sleep mode,
refer to Energy Saver Settings (General Setup) on page 2-21.
Exiting Energy Saver Modes
The following describes how to deactivate an Energy Saver mode.
The machine exits Energy Saver mode and the Energy Saver button light goes off in the following
instances:
Exiting Low Power Mode
•Receiving a job
• Pressing the Energy Saver button
• Entering System Administration mode from a computer
• Pressing any button on the control panel
• Taking paper out or putting in a tray
• Opening or closing the document cover
• Opening or closing any cover of the machine
• Placing a document in the document feeder
Exiting Sleep Mode
•Receiving a job
• Pressing the Energy Saver button
• Entering System Administration mode from a computer
To Next Page
Loading...
