Xerox WorkCentre 5024

Environment Settings
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
2-27
• Primary Server IP Address & Port
You can set the primary WINS server address.
• Secondary Server IP Address & Port
You can set the secondary WINS server address.
Apply button
You can apply changes by pressing this button.
Note Reboot the machine to enable new settings.
LPD (Connectivity > Protocols)
You can set the LPD port.
General
• LPD Port Status
You can check Enabled to use LPD. (Default: On)
•Physical Connection
Ethernet is displayed.
•Port Number
You can set the LPD port No. (a value between 1 and 65535). You must set a unique number for
each port. (Default: 515)
• Connection Time-Out
You can set the timeout period that the machine waits before terminating the connection when
incoming data stops (between 2 and 3600 seconds). (Default: 60)
• Maximum Connections per Port
The maximum number of connections is displayed.
Apply button
You can apply changes by pressing this button.
Note Reboot the machine to enable new settings.
Port9100 (Connectivity > Protocols)
You can set Port9100.
General
•Port9100 Port Status
You can check Enabled to use Port9100. (Default: On)