Too ls
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
9-9
1 1 Sided is set at the time of factory shipment.
Original Type
Sets the default value displayed for Original Type. This setting optimizes the copy characteristics for
the specified document type.
Text is set at the time of factory shipment.
Lighten/Darken
Sets the default copy density value displayed in Lighten/Darken.
You can select Darken +2, Darken +1, Normal, Lighten +1, Lighten +2, or Toner Saver.
Normal sets the copy density at about the same as the document; Darken +2 sets a higher density
than the document; Lighten +2 sets a lower density.
Tone r S aver sets the following values for each feature to conserve the toner usage. Lighten/Darken:
Lighten +2, Sharpness: Sharpen +2, and Original Type: Photo& Text.
Normal is set at the time of factory shipment.
Edge Erase
Sets the default value displayed for Edge Erase. Setting a value for this menu item erases the black
shadows created around the edges of the paper when copying with the document cover open.
You can set values between 0 and 50 mm (in 1 mm increments).
2 mm is set at the time of factory shipment.
1 1 Sided
Set when copying one-sided document on one side of each output page.
1
2 Sided
Set when copying one-sided document on both sides of each output page.
2
1 Sided
Set when copying two-sided document on one side of each output page.
2
2 Sided
Set when copying two-sided document on both sides of each output page.
Text Set when copying documents with sharp black and white contrast, such as text
documents.
Photo & Text Set when copying documents containing both text and photos.
Photo Set when copying photos.
Note: This item is disabled when Color Mode is set to Black & White and enabled
when Color Mode is set to Color.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
