Too ls
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
9-13
Original Type
Sets the default value displayed for Original Type. This setting optimizes the fax scanning
characteristics to the specified document type.
Text is set at the time of factory shipment.
Lighten/Darken
Sets the default fax scanning resolution displayed for Lighten/Darken.
You can select Darken +2, Darken +1, Normal, Lighten +1, or Lighten +2.
Normal sets the fax scanning density at about the same as the document; Darken +2 sets a higher
density than the document; Lighten +2 sets a lower density.
Normal is set at the time of factory shipment.
Original Size
Set the default value displayed for Original Size.
You can select Auto, A3 (297 x 420mm), A4 (210 x 297mm), B4 (257 x 364mm), B5 (182 x
257mm), 8K (270 x 390mm), A5 (148 x 210mm), 11 x 17" , 8.5 x 14" , or 8.5 x 13" .
Auto is set at the time of factory shipment.
Original Size is set to Auto when a document is placed in the document feeder.
Edge Erase
Sets the default value displayed for Edge Erase. Setting a value for this setting erases the black
shadows created around the edges of paper when faxing with the document cover open.
You can set values between 0 and 10 mm (in 1 mm increments).
2 mm is set at the time of factory shipment.
ECM
Sets the default value displayed for ECM. This setting resends the fax if an error resulting in
transmission failure occurs.
You can select On or Off.
Text Set when faxing documents with sharp black and white contrast, such as a text
documents.
Photo & Text Set when faxing documents containing both text and photos.
Photo Set when faxing photos.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
