Yanmar 3JH3E - 3-15 Torque limiter

Chapter 7 Reduction and Reversing Gear
_3_. I_n_s.:..p_e_ct_io_n_an_d_S_e_r_v1_·c_in_g~ ______________________ 3.4JH3(B)(C)E
(3) Standard size of parts
A+A' B
c+c-
KM3P 132.40~132.75
131.20~132.10
141.20~141.55
NOTE : Compare your measurements with the above
standard size.
If your measurements largely dif-
fer from the standard sizes, measurements may
not be correct. Check and measure again.
(4) Adjusting shim set
Tickness. mm (in.)
lnput shaft
Output shaft
3-15 Torque limiter
~-I older
Housing
Shim\
0.5
0.4
0.3
1.0
0.5
0.3
0.1
No.of shims
I
1
2
1
1
2
,,
,J
Coupling
I
The torque limiter assembly includes thes1:,- parts.
-~
The conversion to the torque limiter specification is easy
by exchanging the standard shaft coupling. (Use the
check nut, not the end nut, to install the torque limiter.)
Primed in Japan
HINSHl-118009
D
139.56~141.0D
7-47
E
23.50~24.10
F
57.83~58.65
0-ring
I
I
!,-"'.~~- i.~~~--\
I'""--==_~ __ ='-~:--:. _-.;-:-:-·.:.J:..J2\\(if
mm
Drive cone neutral
center position
47.3
Check Nut