Chapter 8 Remote Control
_3._R_em_o_te_C_o_n_tr_o_l_In_s_p_e_c_ti_on
_______________________
3,4JH3(B)(C)E
3. Remote Control Inspection
(1)
When the control lever movement does not coincide
with operation
of
the engine, check the cable end stop
nut to see whether
or
not it is loose, and readjust/
retighten when necessary.
Free throttle
(2)
Too many bends (turns}
in
the cable or bends
at
too
extreme
an
angle will make it difficult to turn the han-
dle. Reroute the cable to reduce the number of bends
or enlarge the bending radius
as
much
as
possible (to
200mm or more}.
(3)
Check for loose cable bracket/clamp bolts or nuts and
retighten as necessary.
(4) Check cable connection screwheads, cable sleeves
and other metal parts for rust or corrosion. Clean off
minor rust and wax or grease the parts. Replace
if
the
parts are heavily rusted or corroded.
8-4
Printed
in Japan
HINSHI-H8009
To Next Page
Loading...
