Chapter
10
Disassembly and Reassembly
.:.1:...
D=is:..:a::;s::;se:..:m=bl:::Y...;;;an::;d;:...;.R:..;e;.;;a::;ss;;.;e:..:m=bl"'y_P;;..;.re'-c-a;..;.u
...
t1_·o_n_s
_________________
3,4]H3(B)(CJE
3-1. 7 Removing the starting motor
Remove the starting motor from the flywheel housing.
Starting motor
flywheel
housing
3-1
.8
Removing the alternator
(1)
Loosen the alternator adjuster bolt and remove th,
v-belt.
(2)
Removing the adjuster from the fresh water pump,
anc
remove the alternator from the gear case (with dis-
tance piece).
AdJuster
Fresh
water
pump
Alternator
3-1.9 Removing the cooling water pipe
(1) Remove the cooling water (sea water) pipe (lube
oil
cooler-heat
exchanger).
(2)
Remove the cooling water (fresh water) pipe
(heat
exchanger-fresh
water
pump. fresh
water
pump-fresh
water tank).
(3) Remove the cooling water pipe (lube Oil coaler -
marine gearbox).
10-16
Mixing
elbow
~
J~
~~-,,;~H'"'eat
exchanger
3-1.10 Removing the heat exchanger
(exhaust manifold, fresh water tank unit)
Remove the heat exchanger and gasket packing.
Heat
exchanger
Gasket
packing
Cylinder
head
Printed in Japan
HINSHI-H8009
To Next Page
