YASKAWA NX100 - Page 224

9.1 Error Message List
9-6
2250 -
Unmatched number of parentheses in
equation
2260 - Wrong group axis selection
2270 -
Cannot insert any more instruction in
JOB
2280
∗ JOB memory is full
1 Lack of position file memories
2 Lack of JOB registering memories
3 Lack of instruction file memories
4 Lack of memory pool
5
Lack of pass condition file for multi-
layer
2290 - Undefined master JOB
2291
∗ Undefined SUB Master JOB
1 Sub-master 1
2 Sub-master 2
3 Sub-master 3
4 Sub-master 4
5 Sub-master 5
6 Sub-master 6
7 Sub-master 7
8 Sub-master 8
2292 - Undefined MASTER START JOB
2293
∗ Undefined SUB START JOB
1 Sub-master 1
2 Sub-master 2
3 Sub-master 3
4 Sub-master 4
5 Sub-master 5
6 Sub-master 6
7 Sub-master 7
8 Sub-master 8
Error No. Data Error Message Contents