Yealink SIP-T2 Series - Page 386

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series IP Phones
362
Parameters
Permitted Values
Default
X ranges from 1 to 3 (for SIP-T40P/T40G/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
X is equal to 1 (for SIP-T19(P) E2)
Note: The IP phone cannot automatically answer the incoming call during a call or while
dialing even if auto answer is enabled.
Web User Interface:
Account->Basic->Auto Answer
Phone User Interface:
Menu->Features->Auto Answer->Line X->Auto Answer
features.auto_answer.first_call_only
0 or 1
1
Description:
Enables or disables the IP phone to handle the incoming call arriving when the phone is in
another call or is dialing like a normal call.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the incoming call will be automatically answered if you end the
current call or cancel the dialing.
If it is set to 1 (Enabled), the phone rings if you end the current call or cancel the dialing. You
have to manually pick up the incoming call.
Note: It works only if the value of the parameter “account.X.auto_answer” is set to 1
(Enabled).
Web User Interface:
None
Phone User Interface:
None
features.auto_answer_delay
Integer from 1 to 4
1
Description:
Configures the delay time (in seconds) before the IP phone automatically answers an
incoming call.
Note: For the call coming from a SIP account, it works only if the value of the parameter
“account.X.auto_answer” is set to 1 (Enabled).
Web User Interface:
Features->General Information->Auto Answer Delay(1~4s)
Phone User Interface: