8-4
IM AQ7280-01EN
Code Message
648 Can not make file or folder in this folder. (Max 550 files/folder)
690 Cannot save the measurement data. Please confirm the following. - Media is correctly installed. - Media is
formatted. - Media is not read-only.
692 Media is full. Please install new media.
693 Cannot make a folder. Please change the folder name.
694 Cannot open the file. Please confirm the following. - Media is correctly inserted. - Media is not changed.
695 One or more conditions in this file cannot be restored. The instrument automatically determines those conditions.
696 Folder cannot be deleted. Please confirm the following. -There is no file or folder in this folder.
697 Folder can't be copied. The destination folder is a subfolder of the source folder.
698 Folder can not be copied. Please confirm the following. -There is no file or folder in this folder. - Media is correctly
inserted. - Media is formatted. - Media is not read-only.
700 Failed to open the file.
701 Failed to close the file.
702 Failed to read the file.
703 Irregular file format.
704 Failed to write the file.
705 Cannot be saved. No trace data.
706 Cannot be saved. No event data.
707 One or more measurement conditions are not specified. Please confirm the measurement conditions.
708 Cannot be saved. This data is not taken with this instrument.
709 File cannot be retrieved. Distance range exceeds 400 km.
710 File cannot be retrieved. Invalid wavelength
711 File cannot be retrieved. Invalid distance range
712 File cannot be retrieved. Invalid pulse width
713 File cannot be retrieved. Invalid sampling points
714 File cannot be retrieved. Distance range exceeds 400 km.
715 File cannot be retrieved. Sampling intervals exceed 64m.
716 File cannot be retrieved. Actual averaging times or duration is not set.
717 Duplicate file name
718 File is damaged. Check the file.
719 File name too long. Maximum length is 36 letters.
720 File is now being accessed. Execute after access is released.
721 Cannot load this file. Invalid file format or this firmware version is old.
722 Recall Setup File cannot load the measurement condition which sampling interval has been changed to shorter
than the standard sampling interval at Meas. Range Change function.
723 This file cannot be supported by the firmware with this product. Please update into the latest firmware to read this
file.
724 The model name of the instrument and model name in the file is different. This file cannot be read with this
instrument.
725 Can't use the following characters. \ / : ; * ? " < > | % . ,
726 This file cannot be read with this instrument. This file that tries to be loaded includes the measurement condition
that cannot be measured with this instrument.
727 This file cannot be read with this instrument. This file that tries to be loaded includes the measurement condition
that cannot be measured with this instrument. - Distance Range
728 This file cannot be read with this instrument. This file that tries to be loaded includes the measurement condition
that cannot be measured with this instrument. - Pulse Width
729 Project file load failed. Create new project file
730 This project file has individual settings. Conditions cannot be changed using SETUP. Please create new project file
to change setting. Select "Revise project name" to create new file.
731 Checked SOR file does not exist. Please check the SOR files in the folder.
752 Print Error. Printer cannot be found.
754 USB printer error Perform the power cycle.
755 USB printer is offline.
756 No paper (USB printer)
757 USB printer cannot be found. Perform the power cycle.
758 The printer is out of order, and needs to be repaired. Please contact Yokogawa's representatives.
759 Event list cannot be printed because event analysis is not performed.
760 Cannot execute it while printing.
761 This operation is not executed while light is emitting. Stop emitting the light then execute the operation.
800 This function is not supported.
801 FTP Error : Pwd Please confirm network connection and setting.
802 FTP Error : Cwd Please confirm network connection and setting.
8.2 Error Messages
To Next Page
Loading...
