9 - 24 IM 4H3B1-01E
• Even if you disable the keys (by removing the key from the key-hole), you can still
change displays (as in 5.3.8).
•If you disable the keys (by removing the key from the key-hole), you cannot operate
FUNC in the Operation Mode.
• The keys RCD/PRINT/ALARM ACK/FEED can be unlocked/locked individually.
SET Mode:
If you disable the keys (by removing the key from the key-hole), you cannot enter the
SET Mode. If you try, the display will not change.
SET UP Mode:
Even if you disable the keys (by removing the key from the key-hole), you can always
enter and operate the SET UP Mode.
The initial values are ‘NOT’ and ‘LOCK’ for all keys.
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘ON’ the power while pressing and holding the
ENT-key until the SET UP display appears.
Use the UP/DOWN-keys to select the display ‘SETUP=LOCK’. Press the ENT-key.
Select to USE the key-lock or NOT. Press the ENT-key. In the case you selected NOT,
the setting is completed.
Select for the RCD, FEED, ALARM ACK and PRINT-key respectively to have them
LOCKed or to have them FREE. Press the ENT-key after each selection.
The display ‘*LOCK SET*’ will appear.
This setting has been completed, but has not been stored yet. You can now adjust other
settings in the SET UP Mode, by using the ESC-key.
Before leaving the SET UP Mode, you have to store your new settings. Press the ESC-
key to return to the ‘SETUP=LOCK’ display and then select the ‘SETUP=END’
display.
Press the ENT-key. Select ‘END=STORE’ to keep your new settings or
‘END=ABORT’ and press the ENT-key. After a few seconds, the Operation Mode will
appear.
Operation Mode:
9.10 How to Change Key-lock Settings
You can choose to use the key-lock or not.
‘NOT’ : all keys are operable, even when the key is removed from the key-hole.
‘USE’ : to select to ‘USE’ the key-lock affects the 3 modes in different ways.
To Next Page
Loading...
Need help?
General
