3 - 1
IM 4H3B1-01E
3. INSTALLATION
3.1 Installation Site/Mounting
Chapter 3 INSTALLATION
This chapter describes the installation of the µR1800, like the installation site, the
mounting and wiring. To install the µR1800 properly, it is necessary to read this
chapter.
3.1 Installation Site/Mounting
3.1.1 Installation Site
The µR1800 installation site should be chosen to meet the following conditions as close
as possible:
Installation site should be panel-mounted only. The µR1800 is especially designed for
panel mounting.
The µR1800 should be placed in a well ventilated area.
The µR1800 will be adversely affected if the unit is exposed to direct sunlight or
installed near a heater. Choose a location near room temperature (23°C) with minimal
temperature fluctuations.
To expose the µR1800 to soot, steam, moisture, dust, corrosive gases etc. will adversely
affect it.
To use the µR1800 within strong electro-magnetic fields may cause malfunction. Please
avoid installing near electro-magnetic objects.
To install the µR1800 in a location susceptible to mechanical vibrations will adversely
affect the mechanical parts and the quality of recording. Please choose an installation
site characterized by minimal mechanical vibrations.
This µR1800 must be installed horizontally (however, mounting may be inclined up to
30° backwards from vertical).
To use the µR1800 within domestic establishments and within establishments directly
connected to a low voltage power supply network which supplies buildings used for
domestic purposes may cause malfunction of other equipments. Please avoid using in
domestic environment.
To Next Page
Loading...
Need help?
General
