YOKOGAWA µR1800 User Manual

9 - 17
IM 4H3B1-01E
9. CHANGING INITIAL SETTINGS
9.4.3 How to Select the New Chart Speed Printout ON/OFF
You can select the new chart speed printed on the chart when the chart speed changes.
Note that the chart speed will not be printed when the chart speed exceeds 1500 mm/h.
(pen model) or 100 mm/h. (dot model).
The initial value is ‘OFF’.
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘ON’ the power while pressing and holding the
ENT-key until the SET UP display appears.
Use the UP/DOWN-keys to select the display ‘SETUP=RCD’. Press the ENT-key.
Press the ENT-key until the display ‘SPD_PR=...’ will appear. Select ON or OFF.
Press the ENT-key.
This setting has been completed, but has not been stored yet. Before you can adjust
other settings in the SET UP Mode, you have to finish the recording settings until the
‘*RCD SET*’ display appears.
Before leaving the SET UP Mode, you have to store your new settings. Proceed with the
recording settings until the ‘*RCD SET*’ display appears. Press the ESC-key to return
to the ‘SETUP=RCD’ display and then select the ‘SETUP=END’ display.
Press the ENT-key. Select ‘END=STORE’ to keep your new settings or
‘END=ABORT’ and press the ENT-key. After a few seconds, the Operation Mode will
appear.
9.4.4 How to Select the Record Start Time Printout ON/OFF
You can select to get the time printed on the chart when the recording starts. Note that
the time will not be printed when the chart speed exceeds 1500 mm/h. (pen model) or
100 mm/h. (dot model).
The initial value is ‘OFF’.
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘ON’ the power while pressing and holding the
ENT-key until the SET UP display appears.
Use the UP/DOWN-keys to select the display ‘SETUP=RCD’. Press the ENT-key.
Press the ENT-key until the display ‘RCD_PR=...’ will appear. Select ON or OFF.
Press the ENT-key.
This setting has been completed, but has not been stored yet. Before you can adjust
other settings in the SET UP Mode, you have to finish the recording settings until the
‘*RCD SET*’ display appears.
Before leaving the SET UP Mode, you have to store your new settings. Proceed with the
recording settings until the ‘*RCD SET*’ display appears. Press the ESC-key to return
to the ‘SETUP=RCD’ display and then select the ‘SETUP=END’ display.
Press the ENT-key. Select ‘END=STORE’ to keep your new settings or
‘END=ABORT’ and press the ENT-key. After a few seconds, the Operation Mode will
appear.
9.4 How to Change Initial Settings for Digital Printouts

YOKOGAWA µR1800 Specifications

General

Brand	YOKOGAWA
Model	µR1800
Category	Data Loggers
Language	English