YOKOGAWA µR1800 User Manual

3 - 4 IM 4H3B1-01E
3.2 Wiring
This paragraph describes the wiring at the rear panel.
3.2.1 Rear panel arrangement
3.2.2 Power supply wiring
3.2.3 Input wiring
3.2.4 Alarm output wiring
3.2.5 FAIL/Chart end output wiring
3.2.6 Remote control wiring
Make sure to fasten the wiring at the rear wall of the mounting panel and
employ some kind of strain relief between the rear wall and the recorder.
3.2.1 Rear Panel Arrangement
Figure 3.3a Rear Panel Arrangement in case of Pen Model
Figure 3.3b Rear Panel Arrangement in case of Dot Model
!
CAUTION
/B
-/b
+/A
＋
−
1
2
3
4
DC24V
Each terminal block can be
removed for easy wiring
by loosening these screws.
To ensure proper contact,
make sure to fasten the
screws properly.
Used terminal screws:
ISO M4, length: 6mm
Power supply
terminal Block
for /P1 model
Each terminal block can be
removed for easy wiring
by loosening these screws.
To ensure proper contact,
make sure to fasten the
screws properly.
Do NOT change the place of
the terminal block!
Used terminal screws:
ISO M4, length: 6mm
Power supply
terminal block
for /P1 model
+
DC24V
−

YOKOGAWA µR1800 Specifications

General

Brand	YOKOGAWA
Model	µR1800
Category	Data Loggers
Language	English