9 - 15
IM 4H3B1-01E
9. CHANGING INITIAL SETTINGS
9.3.2 How to Assign Different Colors to Channels (Dot Model)
You can assign any of the six provided colors to any channel. The initial setting is as
follows:
ch.1, 7, 13, 19 = purple
ch.2, 8, 14, 20 = red
ch.3, 9, 15, 21 = green
ch.4, 10, 16, 22 = blue
ch.5, 11, 17, 23 = brown
ch.6, 12, 18, 24 = black
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘ON’ the power while pressing and holding the
ENT-key until the SET UP display appears.
Use the UP/DOWN-keys to select the display ‘SETUP=COLOR’. Press the ENT-key.
Select the channel No. for which you want to change a color. Then press the ENT-key.
Select the color. Then press the ENT-key. The display ‘*COLOR SET*’ will appear.
The color setting has been completed, but has not been stored yet. Press the ENT-key to
set the color for other channels or press the ESC-key to adjust other settings in the SET
UP Mode.
Before leaving the SET UP Mode, you have to store your new settings. Press the ESC-
key to return to the ‘SETUP=COLOR’ display and then select the ‘SETUP=END’
display.
Press the ENT-key. Select ‘END=STORE’ to keep your new settings or
‘END=ABORT’ and press the ENT-key. After a few seconds, the Operation Mode will
appear.
9.3 How to Change Initial Settings for Analog Recording
To Next Page
Loading...
