YOKOGAWA µR1800 User Manual

7 - 15
IM 4H3B1-01E
7. BASIC SETTINGS
7.6 How to Copy Channel Settings to Another Channel
–
–
7.6 How to Copy Channel Settings to Another Channel
It is possible to copy settings from one channel to another. If executed, all settings
concerning range, alarm, unit, zone recording, partial expanded recording, periodic
printout and tag will be copied. For the settings concerning zone recording, partial
expanded recording, periodic printout and tag, see 8.1, 8.2. These settings will then all
be copied; it is therefore impossible to copy e.g. alarm-settings only.
The exact contents of these settings will be copied to the specified channel.
Data entry will be ignored for the 1 pen model. To copy, proceed as follows:
MENU:
SETTING PROCEDURE:
Press the MENU-key for three seconds to enter the SET mode.
Select the ‘SET=COPY’ display by using the UP/DOWN-keys.
Then press the ENT-key.
Enter the channel number from which you want to copy using the
UP/DOWN-keys. Note that you can only copy from a lower
channel number to a higher channel number.
Then press the ENT-key.
Then enter the channel number to which you want to copy using
the UP/DOWN- keys. Then press the ENT-key.
The setting is completed.
Press the ENT-key to return to the ‘COPY FROM TO ’
display; or press the ESC-key to go to the ‘SET=COPY’ display;
or press the MENU-key for three seconds to return to the
Operation mode.
1
TO CH
4
RANGE
ALARM
UNIT
CHART
CLOCK
COPY
AUX
FROM CH
SET=COPY
MENU
ESC
PRINT
ALARM
ACK
PRINT
ALARM
ACK
PRINT
ALARM
ACK
COPY FROM 01 TO
COPY FROM 01 TO 04
SET OK
**
3sec
MENU
ESC
3sec

YOKOGAWA µR1800 Specifications

General

Brand	YOKOGAWA
Model	µR1800
Category	Data Loggers
Language	English