7 - 1
IM 4H3B1-01E
7.1 How to Set Input Range and Recording Span
7. BASIC SETTINGS
Chapter 7 BASIC SETTINGS
This chapter explains how to perform the settings of:
(Initial values are given in parentheses.)
7.1 Input range and recording span (VOLT, –2V to +2V)
7.2 Alarms (OFF)
7.3 Units (all spaces)
7.4 Chart speed (25 mm/h)
7.5 Clock
The last paragraph (7.6) explains how settings can be copied to other channels.
7.1 How to Set Input Range and Recording Span
One of the following parameters can be set for every channel:
SKIP Prevents the specified channel from being measured, recorded and displayed
(7.1.1).
VOLT Measures and records DC-voltage (7.1.2).
TC Measures and records temperatures using Thermocouple (7.1.3).
RTD Measures and records temperatures using Resistance Temperature Detector
(7.1.3).
DI Accepts Digital Input (contact/voltage level) and performs ON/OFF
recording (7.1.4).
DELT Performs difference computation between two channels which have same
input range (7.1.5).
SCL Performs scaling on voltage, TC and RTD measurements (7.1.6).
Scaling results in appending a different scale to the measured values.
SQRT Takes the square root ( ) of DC-voltage measured data (7.1.7).
To Next Page
Loading...
Need help?
General
