5 - 1
IM 4H3B1-01E
5. DAILY OPERATION
Chapter 5 DAILY OPERATION
This chapter describes the daily operation of the µR1800, excluding settings.
Please read this chapter carefully before operation.
5.1 How to Switch the Power ON/OFF
The power switch is located behind the door, at the front side, in the middle of the lower
front (see figure 5.1a.). The power is supplied to the instrument when the power switch
is in the position as shown in figure 5.1b. The power is OFF when the power switch is
in the position as shown in figure 5.1b. The power can be turned ON/OFF by alternately
pressing the switch. When you do not use the instrument, please turn ‘OFF’ the power.
Figure 5.1a Figure 5.1b
NOTE After turning ON the power, the µR1800 will first perform a self diagnostic check for
several seconds.
The warm-up time is approx. 30 minutes. (However, just after finishing the
wiring, it might take longer. Especially if you removed the input terminals during
wiring.)
If the input wiring is connected parallel with other equipments, switching the
power ON/OFF should not be done.
If error message appears on the display or is printed on the chart, please refer
to the Error Message Table at sect.12.1.
5.1 How to Switch the Power ON/OFF
ON
OFF
Power switch
CAUTION
To Next Page
Loading...
Need help?
General
