9 - 1
IM 4H3B1-01E
9. CHANGING INITIAL SETTINGS
9.1 How to Change Initial Settings for the Alarm Function
Chapter9 CHANGING INITIAL SETTINGS
This chapter describes how to change initial settings. These settings are entered during
the manufacturing of the recorder and seldom need to be changed.
See 6.3.3 for flow chart.
Note that while you are changing any of the following settings, recording cannot be
performed and alarms will not be detected.
They are grouped into
9.1 How to change initial settings for the alarm function
9.2 How to change initial settings for the input
9.3 How to change initial settings for analog recording
9.4 How to change initial settings for digital printouts
9.5 How to select the type of bargraph
9.6 How to change the temperature unit
9.7 How to initialize settings
9.8 How to change initial settings for the REMOTE option
9.9 How to select to trigger the recording to start/stop
9.10 How to change key-lock settings
9.1 How to Change Initial Settings for the Alarm Function
This paragraph describes how to change initial settings for the alarm function.
9.1.1 How to select the reflash function ON/OFF (initial value = ‘OFF’)
9.1.2 How to select the output relay to be of AND/OR type (initial value = ‘NONE’)
9.1.3 How to select the output relay to be energizing/de-energizing on alarm (initial
value = ‘ENERG’)
9.1.4 How to select the alarm output relay to be of HOLD/NON-HOLD type (initial
value = ‘NONHOLD’)
9.1.5 How to select the alarm indicator to be of HOLD/NON-HOLD type (initial
value = ‘NONHOLD’)
9.1.6 How to set the sampling interval for rate-of-change alarms (initial value = ‘01’)
9.1.7 How to select alarm hysteresis ON/OFF (initial value = ‘ON’)
When exiting SETUP MODE using “SETUP=END” and “STORE” statement.
Do-not turn the power OFF until the Recorder has returned to the OPERATION
MODE. Calibration data might be affected.
Chapter 9 CHANGING INITIAL SETTINGS
CAUTION
To Next Page
Loading...
