SYSTEM TEST MENU
For technical questions, please call 1-888-866-5797.
79
n Min or Max test limit (Only one test limit, either Min or Max, is
shown for any given test)
n Test Value and status
Status is calculated by the Scan Tool by comparing the Test
Value against the displayed test limit (either Min or Max). Status
is shown as either Low, High or OK.
4. When you have finished viewing the retrieved test data, choose Next
to view results for the next test, or choose Back to return to the Select
Test screen.
5. When you have finished viewing test data for all desired tests, choose
Back from the Select Test screen to return to the System Test menu; or,
choose Main Menu to return to the Main Menu.
EVAP Test
The EVAP Test function lets you initiate a leak test for the vehicle's EVAP
system.
The Scan Tool does not perform the leak test, but signals to
vehicle's on-board computer to initiate the test. The vehicle
manufacturer determines the criteria and method for stopping
the test once it has been started. Refer to the vehicle's service
repair manual to determine the procedures necessary to stop
the test.
1. From the System Test menu, select EVAP Test, then press ENTER
.
2. A "One moment please..." message
displays.
3. When the EVAP leak test has been
initiated by the vehicle's on-board
computer, a confirmation message
displays. Choose Back to return to the
System Test menu; or, choose Main
Menu to return to the Main Menu.
Some vehicle manufacturers do not allow Scan Tools or other
external devices to control vehicle systems. If the EVAP Test is not
supported by the vehicle under test, an advisory message displays.
Choose Back (to return to the System Tests menu) or Main Menu,
as desired.
To Next Page
Loading...