ZyXEL Communications GS3700 Series - Configure Rapid Spanning Tree Protocol

Chapter 11 Spanning Tree Protocol
GS3700/XGS3700 Series User’s Guide
138
The following table describes the labels in this screen.
11.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see Section 11.1 on page 132 for more information on
RSTP. Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Figure 94 Advanced Application > Spanning Tree Protocol > RSTP (Standalone mode)
Table 57 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning
Tree. See
Section 11.1 on page 132 for background information on STP.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.