Chapter 43 DHCP
GS3700/XGS3700 Series User’s Guide
422
43.5.1 DHCPv4 VLAN Port Configure
Use this screen to apply a different DHCP option 82 profile to certain ports in a VLAN. To open this
screen, click I P Application > DHCP > DHCPv4 > VLAN > Port.
Figure 312 IP Application > DHCP > DHCPv4 > VLAN > Port
Relay Use this section if you want to configure the Switch to function as a DHCP relay for this
VLAN.
Remote
DHCP Server
1 .. 3
Enter the IP address of a DHCP server in dotted decimal notation.
Option 82 Profile Select a pre-defined DHCP option 82 profile that the Switch applies to all ports in this
VLAN. The Switch adds the Circuit I D sub-option and/or Remote ID sub-option specified in
the profile to DHCP requests that it relays to a DHCP server.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.
VID This field displays the ID number of the VLAN group to which this DHCP settings apply.
Type This field displays Server or Relay for the DHCP mode.
DHCP Status For DHCP server configuration, this field displays the starting IP address and the size of the
IP address pool.
For DHCP relay configuration, this field displays the first remote DHCP server IP address.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Select the configuration entries you want to remove and click Delete to remove them.
Cancel Click Cancel to clear the check boxes.
Table 209 IP Application > DHCP > DHCPv4 > VLAN (continued)
LABEL DESCRIPTION
To Next Page
Loading...
