Chapter 35 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
364
35.7 LLDP-MED Configuration
Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown
next.
Port-Protocol
VLAN ID
Select the check box(es) to enable or disable the sending of IEEE 802.1 Port and Protocol
VLAN ID TLVs on the port(s).
Port VLAN ID Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID
TLVs on the port(s). All check boxes in this column are enabled by default.
Dot3 TLV
Link
Aggregation
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation
TLVs on the port(s).
MAC/ PHY Select the check box(es) to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/ Status TLVs on the port(s). All check boxes in this column are enabled by
default.
Max Frame
Size
Select the check box(es) to enable or disable the sending of IEEE 802.3 Max Frame Size
TLVs on the port(s).
Power Via MDI
Note: For PoE models only.
The Power Via MDI TLV allows network management to advertise and discover the MDI
power support capabilities of the sending port on the remote device.
• Port Class
• MDI Supported
• MDI Enabled
• Pair Controlable
• PSE Power Pairs
• Power Class
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 176 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL DESCRIPTION
To Next Page
Loading...
