Chapter 27 VLAN Mapping
GS3700/XGS3700 Series User’s Guide
305
27.3 Configuring VLAN Mapping
Click the VLAN Mapping Configure link in the VLAN Mapping screen to display the screen as
shown. Use this screen to enable and edit the VLAN mapping rule(s).
Figure 217 VLAN Mapping Configuration (Standalone mode)
Figure 218 VLAN Mapping Configuration (Stacking mode)
Active Select this check box to enable the VLAN mapping feature on this port. Clear this check box
to disable the VLAN mapping feature.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 143 VLAN Mapping (continued)
LABEL DESCRIPTION
To Next Page
Loading...
