Chapter 36 Anti-Arpscan
GS3700/XGS3700 Series User’s Guide
375
Figure 274 Advanced Application > Anti-Arpscan > Trust Host
The following table describes the fields in the above screen.
36.5 Anti-Arpscan Configure
Use this screen to enable Anti-Arpscan, set port and host thresholds as well as configure ports to
be trusted or untrusted. To open this screen, click Advanced Application > Anti-Arpscan >
Configure.
Table 182 Advanced Application > Anti-Arpscan > Trust Host
LABEL DESCRIPTION
Name Type a descriptive name of up to 32 printable ASCII characters to identify this host.
Host IP Type the IP address of the host.
Mask A trusted host may consist of a subnet of IP addresses. Type a subnet mask to create
a single host or a subnet of hosts.
Add Click this to create the trusted host.
Cancel Click this to reset the values above based or, if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each trusted host.
Name This field displays the name of the trusted host.
Host IP This field displays the IP address of the trusted host.
Mask This field displays the subnet mask of the trusted host.
Select an entry’s check box to select a specific entry. Otherwise, select the check box
in the table heading row to select all entries.
Delete Select an entry checkbox and click Delete to remove the specified entry.
Cancel Click this to clear the check boxes above.
To Next Page
Loading...
