ZyXEL Communications GS3700 Series - Chapter 5 ZON Utility, ZON Neighbor Management and Port Status

Chapter 5 ZON Utility, ZON Neighbor Management and Port Status
GS3700/XGS3700 Series User’s Guide
48
The following table describes the fields in the above screen.
Table 6 Status
LABEL DESCRIPTION
Device Information
Device Type This field displays the model name of this Switch.
System Name This field displays the name used to identify the Switch on any network.
Boot Version This field displays the version number and date of the boot module that is current ly on
the Switch.
System Location This field displays the geographic location of your Switch. You can change the setting
in the Basic Setting > General Setup screen.
Firmware Version This field displays the version number and date of the firmware the Switch is currently
running.
System Time This field displays the current date and time in the UAG. The format is mm-dd-yyyy
hh:mm: ss.
Serial Number This field displays the serial number of this Switch. The serial number is used for
device tracking and control.
System Up Time This field displays how long the Switch has been running since it last restarted or was
turned on.
MAC Address This field displays the MAC addresses of the Switch.
Login Timeout This field displays how many minutes a management session can be left idle before the
session times out. After it times out you have to log in with your password again.
Stacking topology
(Stacking mode)
This field displays whether the current topology is Chain or Ring.
Detail Click this link to go to the Basic Setting > System I nfo screen to check other
detailed information, such as system resource usage and the Switch temperature, fan
speeds or voltage.
IP Address Information
IPv4 Address This field displays the Switch’s current IPv4 address.
Subnet Mask This field displays the Switch’s subnet mask.
Default Gateway This field displays the IP address of the Switch’s default gateway.
IP Setup Click the link to go to the Basic Setting > I P Setup screen.
IPV6 Global Unicast
Address
This field displays the Switch’s IPv6 global unicast address.
IPV6 Link-Local
Address
This field displays the Switch’s IPv6 link-local address.
IPv6 configuration Click the link to go to the Basic Setting > I Pv6 screen.
Device Status and
Quick Configuration
This section shows whether a feature is enabled or not on the Switch. You can click a
feature’s Setting link to go to the configuration screen for the feature.
Hover your cursor over a red exclamation mark to display information about the
feature.
Note: The Stacking Status field is displayed only on the Switch with stacking support.
Quick Links This section provides the shortcut link to a specific cofiguration screen.