ZyXEL Communications GS3700 Series - LLDP Configuration Basic TLV Setting

Chapter 35 Link Layer Discovery Protocol (LLDP)
GS3700/XGS3700 Series User’s Guide
361
35.6.1 LLDP Configuration Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP
Configuration > Basic TLV Setting to display the screen as shown next.
Figure 262 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting (Standalone
mode)
Admin Status Select whether LLDP transmission and/or reception is allowed on this port.
• Disable - not allowed
• Tx-Only - transmit only
• Rx-Only - receive only
• Tx-Rx - transmit and receive
Notification Select whether LLDP notification is enabled on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 174 Advanced Application > LLDP > LLDP Configuration
LABEL DESCRIPTION