Chapter 6 Basic Setting
GS3700/XGS3700 Series User’s Guide
61
6.2 General Setup
Use this screen to configure general settings such as the system name and time. Click Basic
Setting > General Setup in the navigation panel to display the screen as shown.
Figure 27 Basic Setting > General Setup
The following table describes the labels in this screen.
Voltage (V) The power supply for each voltage has a sensor that is capable of detecting and reporting if
the voltage falls out of the tolerance range.
Current This is the current voltage reading.
MAX This field displays the maximum voltage measured at this point.
MIN This field displays the minimum voltage measured at this point.
Threshold This field displays the percentage tolerance of the voltage with which the Switch still works.
Status Normal indicates that the voltage is within an acceptable operating range at this point;
otherwise Error is displayed.
Power Source The power source of the Switch has a sensor that is capable of detecting and reporting if
the power source falls out of the normal status.
Status Normal indicates that the power source is within normal status. Error indicates that the
power source is not within normal status. Absent indicates that you do not insert the
power module. Present indicates that you insert the power module, but there is no
available power.
Table 11 Basic Setting > System Info > Hardware Monitor (Stacking Mode) (continued)
LABEL DESCRIPTION
Table 12 Basic Setting > General Setup
LABEL DESCRIPTION
System Name Type a descriptive name for identification purposes. This name consists of up to 64
printable ASCII characters; spaces are allowed.
Location Type the geographic location of your Switch. You can use up to 32 printable ASCII
characters; spaces are allowed.
To Next Page
Loading...
