Chapter 19 Classifier
GS3700/XGS3700 Series User’s Guide
207
Some of the most common IP ports are:
19.4 Classifier Global Setting Configuration
Use this screen to configure the match order and enable logging on the Switch. In the Classifier
Configuration screen click Classifier Global Setting to display the configuration screen as
shown.
Figure 141 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
The following table describes the labels in this screen.
X.25 Level 3 0805
XNS Compat 0807
Banyan Systems 0BAD
BBN Simnet 5208
IBM SNA 80D5
AppleTalk AARP 80F3
Table 89 Common IP Ports
PORT NUMBER PORT NAME
21 FTP
23 Telnet
25 SMTP
53 DNS
80 HTTP
110 POP3
Table 88 Common Ethernet Types and Protocol Number
ETHERNET TYPE PROTOCOL NUMBER
Table 90 Advanced Application > Classifier > Classifier Configuration > Classifier Global Setting
LABEL DESCRIPTION
Match
Order
Select manual to have classifier rules applied according to the weight of each rule you
configured in Advanced Application > Classifier > Classifier Configuration.
Alternatively, select auto to have classifier rules applied according to the layer of the item
configured in the rule. Layer-4 item s have the highest priority, and layer-2 items has the lowest
priority. For example, you configure a layer-2 item (VLAN ID) in classifier A and configure a
layer-3 item (source IP address) in classifier B. When an incoming packet matches both classifier
rules, classifier B has priority over classifer A.
Logging
To Next Page
Loading...
