Chapter 44 VRRP
GS3700/XGS3700 Series User’s Guide
435
44.4 VRRP Configuration Examples
The following sections show two VRRP configuration examples on the Switch.
44.4.1 One Subnet Network Example
The figure below shows a simple VRRP network with only one virtual router VR1 (VRID = 1) and two
switches. The network is connected to the WAN via an uplink gateway G (172.16.1.100). The host
computer X is set to use VR1 as the default gateway.
Figure 324 VRRP Configuration Example: One Virtual Router Network
You want to set switch A as the master router. Configure the VRRP parameters in the VRRP
Configuration screens on the switches as shown in the figures below.
Name This field displays a descriptive name of an entry.
Network This field displays the IP address and subnet mask of an interface.
VRID This field displays the ID number of a virtual router.
Primary VIP This field displays the IP address of the primary virtual router.
Uplink Gateway This field displays the I P address of the uplink gateway.
Priority This field displays the priority level (1 to 255) of the entry.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Table 218 IP Application > VRRP Configuration: Summary (continued)
LABEL DESCRIPTION
172.16.1.100
172.16.1.1
172.16.1.10
To Next Page
Loading...
