ZyXEL Communications GS3700 Series - ARP Inspection Port Configure

Chapter 25 IP Source Guard
GS3700/XGS3700 Series User’s Guide
284
25.8.1 ARP Inspection Port Configure
Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can
also specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To
open this screen, click Advanced Application > I P Source Guard > I Pv4 Source Guard Setup
> ARP I nspection > Configure > Port.
Figure 196 IP Source Guard > IPv4 Source Guard Setup > ARP Inspection > Configure > Port
(Standalone mode)
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Table 132 IP Source Guard > IPv4 Source Guard Setup > ARP Inspection > Configure (continued)
LABEL DESCRIPTION