Chapter 36 Anti-Arpscan
GS3700/XGS3700 Series User’s Guide
373
• Go to Basic Setting > Port Setup. Clear Active and click Apply. Then select Active and
click Apply again.
• Go to Application > Errdiable > Errdisable Recovery and set the interval for Anti-
arpscan. After the interval expires, the closed port(s) will become active and start receiving
packets again.
• Use the command port no inactive.
• Refer to the port logs to see when a port was closed.
36.2 Anti-Arpscan Status
Use this screen to see what ports are trusted and are forwarding traffic or are disabled. To open this
screen, click Advanced Application > Anti-Arpscan.
Figure 272 Advanced Application > Anti-Arpscan Status
The following table describes the fields in the above screen.
Table 180 Advanced Application > Anti-Arpscan Status
LABEL DESCRIPTION
Anti-Arpscan is.... This shows whether Anti-arpscan is enabled or disabled on the Switch.
Port This field displays the port number of the Switch.
Trusted This field displays whether the port is trusted or untrusted. Anti-arpscan is not
performed on a trusted port.
State This field displays whether the port can forward traffic normally (Forw arding) or is
disabled (Err-Disable).
To Next Page
Loading...
